Aem Infinity Supported Applications - Universal V8 Eng Manual do Utilizador descarregar pdf (Página 13)

Universal 8

MSD Distributor + ATI AEM 24 Tooth + Honeywell GT101 Sensor

1. Modify and install mechanical advance distributor. (See Modifying Mechanical Advance Distributor, in

this document.)

2. Install ATI AEM Infinity crank trigger. (Note that an adjustable sensor mount is not provided with the

ATI crank trigger.) Position the crank sensor to be near the middle of its adjustment range while being

in between crank teeth with the engine at TDC. Set sensor air gap to .040”.

3. Wiring:

Crank Sensor – Honeywell GT-101 Sensor

Cam Sensor – Modified MSD Distributor

Wire

Desc

Connect To

Wire

Desc

Connect To

Red

+12V sensor

power

Main relay power out

Black/Purple

Cam signal +

C1-48 Cam Pos Sens 1 VR+

Black

Sensor ground

C1-20 Sensor Ground

Black/

Orange

Cam signal -

C1-47 Cam Pos Sens 1 VR-

White

Crank signal

C1-21 Crk Pos Sens

Hall

Note: Use shielded twisted pair wiring w/drain to ground.

Note: Use shielded wiring with drain to ground.

4. Load ATI 24 + GT101 base session and review Setup Wizard. (See Setup Wizard, in this document.)

5. Sync ignition timing. (See Syncing Ignition Timing, in this document.)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 45 46

Sem comentários

Aem Infinity Supported Applications - Universal V8 Eng Manual do Utilizador Página 13